Dock N Stow Trailer Jack Stand Stabilizing Leveling Block Stores on Tongue Frame

Description

Dock N Stow Trailer Jack Stand, Stabilizing Leveling Block Stores on Tongue Frame, Fits Most Jack Foot Plates, Wheel, RV Camper, Pop Up, Boat, Utility Travel Accessories, Secures with a Bungee, GEN 1
MULTI-USE: Dock N Stow Gen 1 supports most any trailer tongue jack without damaging the trailer. It has a 5000 lb. capacity for any foot or post, round or square and a 2500 lb. wheel dock capacity. For RV's, Boating and Most Bumper Pulled Trailers.
SPACE-SAVER: Gen 1 sits directly on 2, 2.5 or 3-inch trailer tongue or frame with the included dovetail spacers. Stored close to the area of use, you’ll never have to search for a stand again and you'll have more storage space to bring what you need. *Not to be used with C channel or I-beam frames.
SAFETY: Gen 1 secures to square or rectangle tube frames with an included adjustable flat bungee & anti-slip silicone tape. Drive with it safely attached to your trailer. No more climbing up into the truck looking for your block of wood, risking injury.
ADDED HEIGHT: Dock N Stow provides 6 inches of height saving you time trailering or de-trailering, no need to lower your jack to the ground. With the 1/4 inch lip around the top, they are stackable, add another Dock N Stow on top for 12 inches of height.
DURABLE: Gen 1 is extremely durable, engineered and made for the outdoors using high quality ABS plastic which is resistant to UV exposure, water, heat, mud and most other environmental hazards. If Dock N Stow does get dirty, wipe it clean in seconds.
Legal Disclaimer
Failure to read, understand, and follow all instructions before using this device may result in personal injury or property damage.
Visually inspect the equipment prior to each use. If any damage is apparent, remove from service. Prolonged exposure to sunlight can cause the device to weaken. Always use the brake. Chock all tires on the trailer, both in front and behind tires prior to use. Use only on hard, level surfaces. Never place yourself under or behind unstable vehicles. Do not exceed the rated weight. Center the load on the Dock N Stow. Ensure the jack foot or post is flush with the surface of Dock N Stow. Do not make any alterations to this product. Not to be used with aluminum or non-ferromagnetic material. Not to be used on any trailer with less than a 2-inch-wide trailer frame. When not in use, securely fasten the Dock N Stow to the frame of the trailer prior to travel. Not intended for commercial use or with heavy commercial-type trucks or trailers. Failure to heed warnings may result in personal injury and/or property damage. The user assumes all risks for the proper use of this device and for ensuring product suitability for the intended application and safe securement to the trailer before traveling. Dock N Stow GEN2 is designed to be used only on Ferromagnetic metals. All Dock N Stow products are designed for normal conditions, do not use underwater or in a hazardous environment.
Dock N Stow GEN1: Inspect bungee cord before each use, replace annually or as needed. Not to be used on any trailer with I-beam or C-channel construction.
Manufacturer    ‎Dock N Stow
Brand    ‎Dock N Stow
Model    ‎Gen 1
Item Weight    ‎3.36 pounds
Product Dimensions    ‎7 x 7 x 6.25 inches
Is Discontinued By Manufacturer    ‎No
Exterior    ‎Smooth
Manufacturer Part Number    ‎GEN1
Vehicle Service Type    ‎Compatible with all vehicle types. See image and description for trailer frame and beam compatibility.